top of page
GPS Module with EEPROM

GPS Module with EEPROM

SKU: 2
$29.00Price

Includes:

  •  u-blox NEO-6M GY-GPS6MV2 GPS module with on board EEPROM
  • GPS antenna
  • 1x4 male header
  • Tech Specs

    • Input Supply Voltage Range: 3.3V-6V, on board voltage regulator maintains 3.3V
    • I/O Maximum Logic Level: 3.6V
      • We have tested it with direct connection to the 5V serial pins on an Arduino and found it to work fine but extended periods of time may be different
      • To use with a 5V logic device, such as an Arduino, we suggest level shifting the 5V TX signal using one of the following:
        • Two 1N4148 diodes in series between the TX pin on your 5V device and the RX pin on this GPS module (will drop voltage to ~3.6V)
          • Only recommended for baud rates of 9600 and less
        • Use a logic level converter module such as the Addicore Bi-Directional Logic Level Converter
    • WAAS (Wide Area Augmentation System) enabled GPS unit
    • <1 second to first fix (TTFF) for hot starts
    • 27 seconds to first fix (TTFF) for cold starts
    • On board LED will blink after module acquires a position fix and will continue blinking as long as the module has a fix
    • 50 Channel NEMA GPS receiver
    • UART: 9600 baud by default, but is configurable from 4800 to 115200 baud
    • 5Hz max update rate
    • External EEPROM for configuration storage
    • Four plated mounting holes, 3mm in diameter
    • One additional non-plated mounting/antenna cable hole, 4mm in diameter
    • Position Accuracy: 2 m and better with multiple good satellite signals
    • Velocity Accuracy: 0.1 m/s 
    • Maximum Velocity: 500 m/s
    • Heading Accuracy: 0.5 degrees while moving
    • On board battery for battery backed RAM (BBR)
      • Battery is recharged through a simple diode and resistor charger circuit from the on board voltage regulator's 3.3V output
    • Three different power modes (refer to Receiver Description Including Protocol Specification for information on configuring the operating mode)
      • Two continuous operating modes:
        • Maximum Performance Mode - continuously uses the acquisition engine, resulting in the best possible time to first fix (TTFF)
        • Eco Mode - optimizes the use of the acquisition engine to minimize current consumption
      • One intermittent operating mode
        • Power Save Mode - draws only 11mA - Utilizes cyclic tracking, with configurable update periods, which reduces the average power consumption significantly
    • -156dBm Hotstart sensitivity
    • Weight: 17.6g (0.6oz)
    • Dimensions of GPS Module: 36mm (1.42in) x 25.8mm (1.02in) x 4mm (0.16in)
    • Dimensions of Antenna: 25.5mm (1in) x 25.5mm (1in) x 8.8mm (0.35in)
bottom of page